![automotive splice 2 wires into 1 automotive splice 2 wires into 1](https://ae01.alicdn.com/kf/HTB17qTqGL9TBuNjy1zbq6xpepXaY/Universal-100Pcs-Set-Electrical-Cable-Connectors-Quick-Splice-Lock-Wire-Terminals-Crimp-Fast-Easy-Lock-Auto.jpg)
When heat is applied, adhesive-lined insulation shrinks and bonds to the wires, creating a moisture- and corrosion-resistant seal. Connect one wire to two wires of the same size. Once you have confirmed that the wire has been pushed all the way to the back and is lined up correctly press the connector tray down with pliers to secure the connection Multi-Way Heat-Shrink Crimp-On Butt Splices. The wire connectors must be approved for splicing AL/CU wires. Insert wire into the connector and make sure that the wire is pushed all the way to the back of the connector (critical step)Ĥ. A splice can be made between copper and aluminum wire using a wire connector that is approved for joining AL/CU wires together and following the approved methods: Only use wire connectors that are the correct size for the wires to be spliced. You do not need exposed copper to use this connectorģ. Prepare wires to be inserted into both sides of the connector by cutting it flush with the wire casing. Open the top and bottom of the connectorĢ. Great for adding wires to an existing installation or starting a new one. basically just stripo away the part of the cover that you want to tap into, and twist and soder the wire your tapping into the other one onto that open part.
![automotive splice 2 wires into 1 automotive splice 2 wires into 1](https://i.stack.imgur.com/ZftMI.jpg)
The non-weatherproof, insulated wire splice connectors are designed for 24-18 gauge wire and have a secure snap closure to hold wires in place. Use 1/2 wire connectors to easily splice wires without stripping insulation. Slide the heat shrink through one of the wires. Cut a piece of heat shrink to cover the exposed wires. Size: 7*25*6.6mm(single channel), 10.4*25*6.6mm(dual channel) If you are working with stranded wire, try twisting the ends to group the strands together and tinning the tips before soldering.